Лексус RX 300
+ Cars Lexus RX-300
+ Controls and operation receptions
+ Options and car routine maintenance
+ The engine
+ Systems of cooling of the engine, heating, ventilation and air conditioning
+ The power supply system and release of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Automatic transmission and interaxal differential
+ Трансмиссионная a line
+ Brake system
- Suspension bracket and steering
The general information
- Forward suspension bracket
Removal, dismantling, assemblage and installation of a nave and rotary fist
Removal, dismantling assemblage and installation of a rack of a suspension bracket
Removal and installation of the bottom lever of a suspension bracket
Check and replacement of a spherical support of a suspension bracket
Removal, installation and check of the stabilizer of a suspension bracket
+ Back suspension bracket
+ Steering
+ Suspension bracket geometry
+ Body
+ Onboard electric equipment
+ Basic schemes of electric connections
|
Removal, dismantling assemblage and installation of a rack of a suspension bracket Removal, dismantling and check
Components of a rack of a forward suspension bracket
|
|
- Remove a forward wheel.
- Turn out a bolt and remove with скобы the shock-absorber holders of a flexible brake hose and electroconducting of the gauge of speed ABS.
- Disconnect from the shock-absorber a stabilizer rack.
- Give two bottom nuts of fastening of a rack, but yet do not remove bolts.
- At removal of the left rack remove the tank of a brake liquid and separate a socket of the gauge of level of a brake liquid.
- Give three top nuts of fastening of a rack, and then definitively give two bottom nuts and take out bolts.
- Remove assemblage of a rack of a forward suspension bracket.
- Establish two bolts with nuts in the bottom arm of fastening of a rack and clamp it in a vice.
|
|
- By means of the special adaptation compress a spring and, keeping the top saddle of a spring, give a nut.
|
- Remove the top support of a rack, the bearing, the top saddle of a spring and the top cover.
- Pressing and extending a shock-absorber rod make sure of smoothness of its course and absence of unusual sounds. At unsatisfactory results of check replace the shock-absorber.
|
|
Assemblage and installation
|
|
- Establish on the shock-absorber the bottom saddle of a spring and демпфер.
- By means of the special adaptation compress a screw spring and establish it on the shock-absorber.
|
|
The bottom coil of a spring should rest against a groove of the bottom saddle. |
|
|
- Establish the top cover and the top saddle of a spring so that the label not it has been turned outside of the car.
|
- Establish the bearing and the top support of a rack so that the label not it has been turned outside of the car.
- Tighten a nut of fastening of a spring and remove from a spring the special adaptation.
- Installation is made upside-down. In summary check up corners of installation of forward wheels.
|
|
|
|
