Лексус RX 300
+ Cars Lexus RX-300
+ Controls and operation receptions
+ Options and car routine maintenance
+ The engine
+ Systems of cooling of the engine, heating, ventilation and air conditioning
+ The power supply system and release of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Automatic transmission and interaxal differential
+ Трансмиссионная a line
+ Brake system
- Suspension bracket and steering
The general information
+ Forward suspension bracket
- Back suspension bracket
Removal, dismantling, assemblage and installation of a nave of a back wheel
Removal, dismantling, assemblage and installation of a rack of a suspension bracket
Removal and installation of the stabilizer of a suspension bracket
Removal and installation of levers of a back suspension bracket
+ Steering
+ Suspension bracket geometry
+ Body
+ Onboard electric equipment
+ Basic schemes of electric connections
|
Removal and installation of levers of a back suspension bracket
Components of installation of levers of a back suspension bracket
|
|
- Remove a back wheel.
- Remove the central and back sections of an exhaust pipe.
- Turn out a bolt and remove from a body an arm of a cable of a lay brake.
- At a corresponding complete set turn out a nut and disconnect draught of the gauge of adjustment of an inclination of headlights from cross-section draught №2 back suspension brackets.
- Turn out two bolts, a nut and remove the longitudinal lever of a suspension bracket.
- Put adjusting labels on the clown of adjustment of convergence of back wheels and on a stretcher.
- Turn out a bolt and a nut, remove the clown and disconnect cross-section draught №2 from a stretcher.
- Turn out a bolt and a nut of fastening of cross-section draught №2 to ступичной to assemblage and remove draught.
- Turn out a bolt and a nut of fastening of cross-section draught №1 to ступичной to assemblage and disconnect from it draught.
- Ослабьте an adjusting bolt of the cross-section lever №1 to a back stretcher.
|
|
Do not remove a bolt entirely. |
- Prop up a back stretcher a jack, turn out 4 nuts, 2 bolts and remove two holders from a back stretcher.
- Lower a jack, completely turn out a bolt of fastening of the cross-section lever №1 to a back stretcher and remove the lever.
- Installation is made upside-down. In summary check up and if necessary adjust corners of installation of back wheels.
|
|
|
|
