Лексус RX 300
+ Cars Lexus RX-300
+ Controls and operation receptions
+ Options and car routine maintenance
+ The engine
+ Systems of cooling of the engine, heating, ventilation and air conditioning
+ The power supply system and release of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Automatic transmission and interaxal differential
+ Трансмиссионная a line
+ Brake system
- Suspension bracket and steering
The general information
+ Forward suspension bracket
+ Back suspension bracket
+ Steering
- Suspension bracket geometry
Corners of installation of wheels of the car - the general information
Check and adjustment of corners of installation of forward wheels
Check and adjustments of corners of installation of back wheels
+ Body
+ Onboard electric equipment
+ Basic schemes of electric connections
|
Check and adjustment of corners of installation of forward wheels Check
|
|
Check of geometrical parametres of a suspension bracket is made at the special stand in the conditions of a car-care centre workshop. Data for check and adjustment of wheels are resulted in Specifications of the Head the Suspension bracket and a steering. |
|
|
|
|
- Measure distances from the earth to the centre of a forward bolt of fastening of the bottom lever of a forward suspension bracket and to the centre of a forward bolt of fastening of the longitudinal lever of a back suspension bracket. Compare the received values to requirements of Specifications of the Head the Suspension bracket and a steering.
|
- Establish the car on the measuring stand and check up disorder corners, выбега and an inclination of an axis of turn of wheels. If at normal disorder corners выбега and an inclination of an axis of turn of wheels mismatch requirements of Specifications of the Head the Suspension bracket and a steering, check up suspension bracket components on presence of damages and deterioration.
|
|
- Check up convergence of wheels.
|
- Turn against the stop a steering wheel and measure limiting corners of turn of wheels. At unsatisfactory results of check check up lengths of the left and right steering draughts.
|
|
Disorder adjustment
|
|
After disorder adjustment check up convergence of wheels. At adjustment of a corner of disorder try to expose its average value. |
|
|
- Remove forward wheels and holders of gauges of speed ABS.
- Give two bottom nuts of fastening of a rack of a forward suspension bracket to a rotary fist.
|
|
- Grease a carving of nuts (1) and (2) impellent oil and temporarily establish them.
|
- Adjust disorder pressing or delaying the bottom part of a rack in a corresponding direction.
- Tighten nuts with effort of 210 Nanometers. Establish forward wheels.
- Again check up a disorder corner.
- The range of adjustment of the established bolts makes from 6 ' to 30 '. If necessary it is possible to pick up adjusting bolts according to the table resulted more low.
- After отдавания nuts replace a bolt () on picked up (if necessary).
|
|
Convergence adjustment
|
|
- About protective covers also give counternuts of tips of steering draughts.
|
|
- Turn steering draughts on the quantity of turns necessary for installation of average спецификационного of value of convergence.
|
|
|
- Make sure, that residual lengths of the right and left steering draughts differ no more, than on 1.5 mm.
|
- Tighten counternuts of tips of steering draughts with effort of 74 Nanometers. Also establish protective covers.
|
|
|
|
