LEXUS RX 300

1998-2003 of release

Repair and car operation



Лексус RX 300
+ Cars Lexus RX-300
+ Controls and operation receptions
+ Options and car routine maintenance
+ The engine
- Systems of cooling of the engine, heating, ventilation and air conditioning
   + System of cooling of the engine
   - Systems of heating, ventilation and air conditioning
      The general information
      Replacement, dismantling and block K/V assemblage
      Removal, dismantling, assemblage and installation of the block of the fan of a heater
      Check and replacement of the compressor and magnetic муфты К/В
      Removal and condenser K/V installation
      Checks of components of systems of heating and К/В
      Removal and installation of the block of management
+ The power supply system and release of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Automatic transmission and interaxal differential
+ Трансмиссионная a line
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Basic schemes of electric connections




Check and replacement of the compressor and magnetic муфты К/В

Check

 PERFORMANCE ORDER

  1. Start the engine and make sure of absence of a metal sound from the compressor at inclusion К/В. If necessary replace compressor assemblage. If abnormal noise is audible at deenergizing К/В, replace magnetic муфту.
  2. Having the necessary equipment and skills, check up pressure of a coolant and compare it to requirements of Specifications of the Head of System of cooling of the engine, heating, ventilation and an air conditioning.
  1. Separate a socket of the gauge of blocking of the compressor, measure resistance between its contacts 1 and 2 and compare the received result to requirements of Specifications of the Head of System of cooling of the engine, heating, ventilation and an air conditioning. If necessary replace compressor assemblage. Connect a negative wire from the battery to the gauge case, and positive – to contact 3, – thus it should be activated magnetic муфта. Otherwise replace муфту.
  1. Make sure of absence of leaks of a coolant through a control epiploon. If necessary replace the compressor in gathering.
  2. Visually check up tightness of the bearing муфты. Make sure of absence of traces of oil on a press plate.

Replacement

Components of assemblage and compressor K/V installation

1 — the Generator
2 — the Digit hose
3 — the Sealing ring
4 — the Soaking up hose
5 — Приводной a generator and compressor K/V belt
6 — the Compressor
7 — the Bottom casing of an impellent compartment

8 — the Arm of adjustment of a tension приводного a belt
9 — the Press plate
10 — Washers
11 — the Rotor
12 — Статор
13 — the Lock ring


 PERFORMANCE ORDER

  1. Загустите the engine on single turns at included К/В, allow to it to work 10 minutes and switch off the engine.
  2. Disconnect a negative wire from the storage battery.
  3. Discharge system K/V and remove приводной a generator and compressor K/V belt (the Section Check of a condition and replacement of belts of a drive of auxiliary units see).
  1. Turn out a bolt with a nut and disconnect soaking up hoses. After a detachment as soon as possible закупорьте open branch pipes.
  1. Remove the generator (see the Head of System of an electric equipment of the engine).
  1. Separate a socket of electroconducting of the compressor, turn out two bolts, a nut and remove an arm of adjustment of a tension приводного a belt.
  1. Turn out three bolts and remove the compressor.
  2. Installation are made in an order, the return to an order of dismantle of components.