LEXUS RX 300

1998-2003 of release

Repair and car operation



Лексус RX 300
+ Cars Lexus RX-300
+ Controls and operation receptions
+ Options and car routine maintenance
+ The engine
+ Systems of cooling of the engine, heating, ventilation and air conditioning
+ The power supply system and release of the fulfilled gases
- Systems of an electric equipment of the engine
   + Ignition and engine management systems
   + Diagnostics of systems of electronic control and the diagnostic equipment
   - Charge and start systems
      The general information
      The storage battery - the general information, recommendations about service
      Charge system - the general data and security measures
      Check of system of a charge
      Removal and generator installation
      System of start of the engine - the general information
      Removal and starter installation
+ Automatic transmission and interaxal differential
+ Трансмиссионная a line
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Basic schemes of electric connections




Removal and generator installation

Details of installation of the generator

1 — the Flat washer
2 — Шарнирный a bolt
3 — the Fixing bolt of adjustment of a tension приводного a belt
4 — a generator Wire

5 — a generator Socket
6 — the Generator
7 — the Bolt of adjustment of a tension приводного a generator belt
8 — Приводной a generator and compressor K/V belt

Details of assemblage of generator L3B

1 — a generator Washer
2 — a bearing Cover
3 — the Back bearing
4 — the Rotor
5 — the Forward bearing
6 — the Holder
7 — the Cover from a drive

8 — the Pulley
9 — the Back sealing plate
10 — the Forward sealing plate
11 — a contact Insulator
12 — Щёткодержатель
13 — the Back cover
14 — winding Assemblage

Details of assemblage of generator SC1

1 — the Washer the generator
2 — a bearing Cover
3 — the Back bearing
4 — the Rotor
5 — the Forward bearing
6 — the Holder
7 — Статор (a cover from a drive)
8 — the Pulley
9 — the Plug
10 — the Cover щёткодержателя

11 — a contact Insulator
12 — the Sealing plate
13 — an electroconducting Clip
14 — the Cover from the rectifier
15 — the Back cover
16 — Щёткодержатель
17 — a pressure Regulator
18 — the Holder of the rectifier
19 — the Rubber insulator


 PERFORMANCE ORDER

  1. Disconnect a negative wire from the battery.
  2. Remove приводной a belt (see the Head of Adjustment and car routine maintenance).
  3. Separate a generator socket.
  4. Give a nut and disconnect from the generator a wire.
  5. Disconnect burn down electroconductings from the holder.
  6. Turn out шарнирный a bolt, remove the flat washer, fixing bolt of adjustment of a tension приводного a belt and the generator.
  7. Installation is made in an order, the return to an order of dismantle of components.