LEXUS RX 300

1998-2003 of release

Repair and car operation



Лексус RX 300
+ Cars Lexus RX-300
+ Controls and operation receptions
+ Options and car routine maintenance
+ The engine
+ Systems of cooling of the engine, heating, ventilation and air conditioning
+ The power supply system and release of the fulfilled gases
- Systems of an electric equipment of the engine
   + Ignition and engine management systems
   + Diagnostics of systems of electronic control and the diagnostic equipment
   - Charge and start systems
      The general information
      The storage battery - the general information, recommendations about service
      Charge system - the general data and security measures
      Check of system of a charge
      Removal and generator installation
      System of start of the engine - the general information
      Removal and starter installation
+ Automatic transmission and interaxal differential
+ Трансмиссионная a line
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Basic schemes of electric connections




Removal and starter installation

Details of installation of a starter

Details of assemblage of a starter

1 — Ограничительно a ring
2 — the Spring
3 — the Plate a spring
4 — the Lock plug
5 — the Gear wheel
6 — the Forward cover
7 — Обгонная муфта
8 — the Spring
9 — a drive Shaft
10 — Assemblage of a forward cover and обгонной муфты
11 — the Intermediate gear wheel
12 — the Bearing

13 — the Returnable spring
14 — the Steel ball
15 — the Traction relay
16 — the Forward bearing
17 — the Anchor
18 — the Back bearing
19 — the Sealing ring
20 — the Case with a field winding
21 — the Sealing ring
22 — the Back cover
23 — Щёткодержатель
24 — the Sealing ring
25 — Пыльник


 PERFORMANCE ORDER

  1. Disconnect a negative wire from the battery.
  2. Remove an air cleaner (see the Head of the Power supply system and release of the fulfilled gases).
  3. Separate a starter socket.
  4. Turn out a nut and disconnect a starter wire.
  5. Turn out two fixing bolts and remove a starter.
  6. Installation is made upside-down.