LEXUS RX 300

1998-2003 of release

Repair and car operation


Лексус RX 300
+ Cars Lexus RX-300
+ Controls and operation receptions
+ Options and car routine maintenance
+ The engine
+ Systems of cooling of the engine, heating, ventilation and air conditioning
+ The power supply system and release of the fulfilled gases
+ Systems of an electric equipment of the engine
- Automatic transmission and interaxal differential
   The general information
   Search of malfunctions - the general information
   Replacement of gauges
   Removal and installation of assemblage of valves AT
   Checks and adjustments АТ
   Removal and installation of cooler ATF
   Removal and installation of assemblage of the lever of the selector of modes АТ
   Removal and installation АТ
+ Трансмиссионная a line
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Basic schemes of electric connections



Removal and installation АТ

Components of installation АТ (U140F)

1 — the Plait and electroconducting sockets
2 — a weight Cable
3 — the Right support
4 — the Right rack of an exhaust pipe
5 — Transmission

6 — the Stopper of an aperture for pressure measurement in lines АТ
7 — the Starter
8 — the Left rack of an exhaust pipe
9 — the Bottom cover приводного a disk


 PERFORMANCE ORDER

  1. Remove the power unit from the car (see Has undressed Removal and engine installation, check of support).
  2. Remove a starter (see Has undressed Removal and starter installation).
  3. Turn out bolts and nuts and remove the left and right racks of an exhaust pipe.
  4. Turn out 5 bolts and remove the right support.
  5. Turn out 2 bolts the bottom cover приводного a disk.
  6. Turning a cranked shaft, turn out fastening bolts муфты the hydrotransformer.
  1. Turn out three bottom bolts of fastening АТ.
  1. Turn out bolts of fastening of cables of weight to АТ and disconnect these cables.
  2. Disconnect from АТ following sockets:
    • Socket Д/В of a mode «P» / «N»;
    • Electroconducting socket э/м the valve;
    • Socket of the gauge of entrance turns of the hydrotransformer;
    • Socket of the gauge of speed of an auxiliary gear wheel.
  3. Liberate burn down electroconductings from holders.
  4. Turn out 5 top bolts of fastening АТ and disconnect a weight cable.
  5. Remove АТ.
  6. Installation is made upside-down. Tighten fixture with demanded effort.
  7. After installation adjust a drive of a gear change and Д/В modes «P» / «N». Fill АТ with liquid ATF, check up its level. Make a trial trip on the car.