LEXUS RX 300

1998-2003 of release

Repair and car operation


Лексус RX 300
+ Cars Lexus RX-300
+ Controls and operation receptions
+ Options and car routine maintenance
+ The engine
+ Systems of cooling of the engine, heating, ventilation and air conditioning
+ The power supply system and release of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Automatic transmission and interaxal differential
+ Трансмиссионная a line
- Brake system
   The general information and security measures
   Removal, installation and check of pedals of brake system
   Check of brake system through a socket of the module of management
   Removal and installation of the tank and the main brake cylinder (ГТЦ)
   Removal, check and installation of the amplifier of brakes
   Replacement brake колодок
   Removal, dismantling, check, assemblage and installation of supports of brake mechanisms
   Dismantling, check and assemblage of a lay brake
   Check of the valve of distribution of brake effort
   Removal and installation of the activator of brakes
   Removal and installation of wheel gauges
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Basic schemes of electric connections



Removal, installation and check of pedals of brake system

Check and adjustment of a course of pedals of a working and lay brake are resulted in Section Check and adjustment of a course of pedals of a working and lay brake.

Components of installation of a pedal of a working brake

1 — the Plug
2 — the Pillow
3 — the Pin
4 — the Wavy washer

5 — the Pedal of a working brake
6 — a pedal Overlay
7 — Шплинт
8 — the Returnable spring

Components of installation of a pedal of a lay brake

1 — the Socket of the switch of a lay brake
2 — Assemblage of a pedal of a lay brake
3 — the Switch of a lay brake

4 — the Pedal of a drive of a lay brake
5 — a pedal Overlay
6 — the Cable of a lay brake
7 — the Clip


 PERFORMANCE ORDER

  1. The description of removal of a pedal of a drive of a lay brake is more low resulted.
  2. Remove the bottom left section of the panel of devices (the Body see the Head).
  3. Release a pedal of a lay brake.
  4. Separate a socket of electroconducting of the switch of a lay brake
  5. Give 3 nuts and remove assemblage of a pedal of a drive of a lay brake.
  6. Remove a clip and disconnect a torso of a drive of a lay brake.
  7. Turn out the screw and remove the switch of a lay brake.
  8. Remove from a pedal an overlay.
  9. Installation is made upside-down.