LEXUS RX 300
1998-2003 of release
Repair and car operation
Лексус RX 300
+ Cars Lexus RX-300
- Controls and operation receptions
+ Access, protection
+ Elements of systems of safety
+ The car equipment, arrangement of devices and controls
+ Devices of maintenance of comfort
- Receptions of operation and auxiliary systems
Start of the engine and the movement beginning
Management of automatic transmission (AT)
Гидроусилетиль a steering
Features of operation of the cars equipped каталетическим with the converter
+ Options and car routine maintenance
+ The engine
+ Systems of cooling of the engine, heating, ventilation and air conditioning
+ The power supply system and release of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Automatic transmission and interaxal differential
+ Трансмиссионная a line
+ Brake system
+ Suspension bracket and steering
+ Onboard electric equipment
+ Basic schemes of electric connections
The brake system of considered cars is equipped by the vacuum amplifier allowing for braking with certain intensity to put to a pedal of a brake smaller effort, than it would be required without the amplifier. If the amplifier does not work (at the idle engine or for other reason), the working brake system remains serviceable, however to press on a brake pedal is required with большей force, and the brake way, as a rule, will increase.
At the idle engine by each pressing a brake pedal the additional effort of braking decreases, therefore it is not necessary to press a brake pedal at the idle vacuum amplifier without necessity (for example, at driving deduction on slippery road).
In default brakes during movement braking by means of a lay brake is supposed, however it is necessary to remember always that the brake way in this case will exceed much more a brake way at use of working brakes.
Forward and back brake mechanisms
On considered cars disk brake mechanisms are established. Indicators of their deterioration which start to publish a high sound at movement or by pressing a brake pedal if overlays demand replacement are built in brake overlays. Thus it is necessary to replace overlays whenever possible more likely to avoid further more expensive repair.
On the European models the lever of a lay brake is located on the central console, between forward seats. For raising of a lay brake pull the lever upwards against the stop. For отпускания a lay brake press the button located on the free end of the lever, and lower the lever downwards, keeping the button of the pressed.
On the American models the lay brake is resulted by a pedal (the Scheme of an arrangement of elements of management see the panel of devices an illustration). For raising of a lay brake press a pedal of working brake system and, keeping it, squeeze out a pedal of a drive of a lay brake and release a pedal of a working brake. For отпускания a lay brake press a pedal of a working brake, then, keeping it, press and release a pedal of a drive of a lay brake – it should return to the top position.
At a stop on lifting park the car as it is possible more close to sidewalk or a roadside and turn wheels to the road centre that at casual movement of the car back forward wheels would rest in бордюрный a stone.
At a stop on descent park the car as it is possible more close to sidewalk or a roadside and turn wheels to a roadside that at casual movement of the car back forward wheels would rest in бордюрный a stone.
At each start of the engine check К/Л brake system (the car Equipment, an arrangement of devices and controls see) – at cocked lay brake К/Л should burn, and after it отпускания К/Л should die away. If after отпускания a lay brake it К/Л continues to burn, it specifies in malfunction in brake system which should be corrected before to begin movement. If К/Л has lighted up during movement, stop at the first possibility and eliminate malfunction.
System of antiblocking of brakes (ABS)
System ABS constantly traces speed of rotation of wheels of the car and at their blocking repeatedly modulates hydraulic pressure in brake system.
At braking in conditions which can lead to blocking of wheels, it is possible to hear clicks in brake mechanisms, or to feel pulsations of a pedal of a brake. The listed phenomena are a consequence of normal work of system ABS and mean its activity. It is not necessary to change thus effort of pressure to a brake pedal since it will prevent system ABS to work with peak efficiency.
It is necessary to remember following safety measures always:
Check К/Л systems ABS at engine start, - it should light up for 2-3 seconds, and then go out. If К/Л does not die away, means ABS it is faulty, thus the working brake system can function normally. К/Л systems ABS can join and at long braking on slippery road. If it has occurred, stop and muffle the engine. If after engine K/L restart will not go out, drive away the car on HUNDRED for diagnostics and malfunction elimination.