LEXUS RX 300

1998-2003 of release

Repair and car operation


Лексус RX 300
+ Cars Lexus RX-300
+ Controls and operation receptions
+ Options and car routine maintenance
+ The engine
+ Systems of cooling of the engine, heating, ventilation and air conditioning
+ The power supply system and release of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Automatic transmission and interaxal differential
+ Трансмиссионная a line
+ Brake system
- Suspension bracket and steering
   The general information
   - Forward suspension bracket
      Removal, dismantling, assemblage and installation of a nave and rotary fist
      Removal, dismantling assemblage and installation of a rack of a suspension bracket
      Removal and installation of the bottom lever of a suspension bracket
      Check and replacement of a spherical support of a suspension bracket
      Removal, installation and check of the stabilizer of a suspension bracket
   + Back suspension bracket
   + Steering
   + Suspension bracket geometry
+ Body
+ Onboard electric equipment
+ Basic schemes of electric connections



Removal, installation and check of the stabilizer of a suspension bracket

Components of installation of the stabilizer of a forward suspension bracket

1 — a stabilizer Rack
2 — Скоба
3 — the Plug

4 — a plug Stopper
5 — Скоба №2
6 — the Holder of a stopper


 PERFORMANCE ORDER

  1. Remove both lobbies of a wheel.
  2. Turn out on two nuts from each party and remove both racks of the stabilizer (serially).

If hinges are turned together with nuts, keep them шестигранным a key on 5 mm.

  1. Serially turn out on two bolts and remove скобы and stabilizer plugs.
  2. Remove the stabilizer.
  3. By means of a screw-driver remove the holder of a stopper of the plug, and then remove a stopper.
  1. Clamp in a vice the hinge of a rack of the stabilizer and shake its tip forward-back about five times.
  1. Continuously tightening динамометрическим as a key a nut of the hinge with a speed 1 turn for 2 ÷ 4 with, consider key indications on the fifth turn and compare them to requirements of Specifications of the Head the Suspension bracket and a steering. If necessary replace a stabilizer rack.
  2. Installation is made upside-down. The stabilizer plug establish outside of a plug stopper; the stabilizer establish the marked paint the party to the left board of the car.